Step 1 : Remove all spark plugs from the engine
Inspect all the spark plugs
(Corrosions are normal from normal use)
Step 2 : Use wire brush & sand paper to carefully clean the carbon builds up
(Carefully do not scrape the tip of electrodes)
Step 4 : Get some paint or markers to mark the side of the spark plug following the tip of the spark plug
(This marking is a guide to see where the tip of the spark plug when its sits inside the block)
The Results :
Depending on spark plug models & usage,
some plugs may have to use some new washers to seat it perfectly
Cylinder 1 :
Cylinder 2:
Cylinder 3:
Cylinder 4:
Place everything all together and your done.
Start the engine & feel the difference.
No comments:
Post a Comment